Featured Products
JOTUN
Penguard HB
Penguard HB is a high build, two-pack pure epoxy primer. It is ideal for application on GRP or gelcoat as it provides excellent waterproofing and will help prevent osmosis.
JOTUN
Pioner Topcoat
Jotun Pioner Topcoat is a single pack, semi-gloss, acrylic topcoat which is suitable for use both above and below the waterline.
JOTUN
Vinyguard Silvergrey 88
Vinyguard Silvergrey is a quick drying, modified vinyl primer, recommended as a tie coat or as a sealer for an antifouling system. It is very water resistant and is excellent above and below the waterline as part of a single pack paint system.
SML
CU-PRO Antifouling 5L
Premium self-polishing antifouling with a commercial grade biocide to give service interval of up to three years.
SML LUSTRE
Gloss - Silicone Alkyd Topcoat
Easy to apply, high gloss topcoat with excellent durability and colour retention.
SML SHIELD
High Build Epoxy Primer 2.5L
A 2-pack high build epoxy primer for use above or below the waterline, or as a build coat over Shield Surface Tolerant Epoxy Primer.
SML LUSTRE
Low Sheen - Silicone Alkyd Topcoat
Easy to apply, low sheen topcoat with excellent durability and colour retention.
SML SHIELD
Bilge Paint 2.5L
Fast-drying bilge paint, primer/finish coat, to protect steel & GRP, & giving excellent water, diesel and chemical resistance. Easy application to all types of bilge including Yachts and Canal Boat.
SML
Ballastic Black
Ballastic Black is a traditional bitumen hull blacking. It has a higher percentage of volume solids than both Intertuf 16 and Rylards Rytex, It can be applied on bare steel or over existing coatings.
SML
Ballastic Epoxy 5L
A high build epoxy with extended durability, suitable for use above and below the waterline.
SML
CU-PRO Antifouling 2.5L
Premium self-polishing antifouling with a commercial grade biocide to give service interval of up to three years.
.jpg)
JOTUN
Clipper II 2.5L
Clipper II is a urethane based varnish that is suitable for all wooden surfaces above the water line. Clipper II provides a clear, glossy and hard wearing surface.
JOTUN
Steelmaster 900WF
Marine Paint Guide
PLEASE READ THIS FIRST IF YOU HAVE NOT USED MARINE PAINTS BEFORE
A typical paint system will usually comprise of a primer and a topcoat onto a prepared bare substrate such as metal, GRP/fibreglass/gelcoat, wood or concrete. The primer serves as a thicker, protective layer and/or provides a good surface for a topcoat. The topcoat is usually a much thinner coating that provides an aesthetic finish and a final colour. With modern paints a mid-coat or undercoat is not always required especially if the primer can be mixed in a colour to complement the topcoat.
