Jotun Tankguard HB is a high build epoxy coating that has an excellent resistance to a wide range of chemicals and solvents. It is used extensively in gas and oil storage tanks and pipelines.
It can be used as a primer, mid coat or finish coat in atmospheric and immersed environments, and it is suitable for properly prepared carbon steel, galvanised steel and concrete substrates.
Typical Marine uses: Designed as an internal tank coating for chemical tanks, including grey water, drilling mud, brine and crude oil tanks.
Typical Protective uses: Recommended as an internal lining for offshore, onshore and buried tanks and pipes.
|Surface preparation||Minimum Sa 2.5|
|Surface dry at 23 C||3.5 hours|
|Pot life at 23 C||8 hours|
|Induction time at 23 C||30 minutes|
|Dried / cured for service at 23° C||7 days|
|Application||Airless spray recommended|
Ballastic Black is a traditional bitumen hull blacking. It has a higher percentage of volume solids than both Intertuf 16 and Rylards Rytex, It can be applied on bare steel or over existing coatings.
A high build epoxy with extended durability, suitable for use above and below the waterline.
Offers the longest lifetime in any environment. It has exceptional corrosion resistance, is surface tolerant and fast drying - greatly improving efficiency, It is also available in a wide range of colours.
A two-pack polyamine cured novolac epoxy tank lining with excellent chemical resistance. It can be used as primer, mid coat or finish coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, stainless steel, and concrete substrates. Typical use: As internal lining for offshore, onshore and buried tanks and pipes such as chemical storage, waste water, grey water, process water, concrete bund, fire service lines and drilling mud tanks. Can be used in pressure vessels. This coating has very good resistance to high temperature products. Available in Light Grey, Light Red and Red, in 18.8 L packs. Note; Colours are approximations and are not matched. Slight batch deviations will be observed.
Designed for drinking water tanks, Tankguard DW is a two-pack solvent-free epoxy coating. It can be used as primer and finish coat in atmospheric & immersed environments, and is suitable for properly prepared carbon steel, stainless steel, and concrete substrates. Typical use: Coating for potable water tanks and pipes. It is independently tested and certified for potable water storage. Tankguard DW is available in white, in a 15 L pack. (Buff & Light Grey may also be available, please call for information.)
This is a two component polyamine cured epoxy mastic coating. It is a surface tolerant, high solids, high build product. Specially designed for areas where optimum surface preparation is not possible or desired.